Solid SLA project 811, Test of making 3Dprinter with out motion control

News

New release 2019/06/14

This test unit is change Y axis from motor slide to Sonic slide. X axis and Z axis is keep traditional type.
Resin tank is using world standard form type incubation cartridge.

Fig No,01 This is standard type of incubation cartridge.
Fig No,02 We put small speaker in side of cartridge
Fig No,03 Power cable is come from top side

Fig No,04 RJ-45/35 socket is connected for PIN/PLUG type
Fig No,05 Solid switch for power
Fig No,06 Here is power for plastic FDM head.

Fig No,07 Video CCD unit / USB interface
Fig No,08 Micro phone and plug interface
Fig No,09 Each signal cable for each color.

Fig No,10 Hole for Solid switch unit
Fig No,11 Set tope side and long spacer
Fig No,12 Setting unit

Fig No,13 Wire harness with switch
Fig No,14 X axis motor wire harness for computer interface
Fig No,15 Setting RJ-45/35 Socket to base panel

Fig No,16 Side view of X axis drive socket
Fig No,17 X axis drive socket and plug with wire
Fig No,18 Z axis drive socket and plug with wire

Fig No,19 3Dprinter unit on incubation cartridge ( Material tank )
Fig No,20 Incubation cartridge and connect of power wire
Fig No,21 Z axis drive socket on base panel ( plus another tool )

Attention
A corporate name, the brand name, and the design logo that has been described are the trademarks or registered trademarks of each company.
Biological Process System Technology Taiwan copyright(C)All rights reserved 2019